Product Variations
Drum - 54.2 gal / 205 L
Pail - 5 gal / 18.9 L
Can - 3.78 L / 1 gal
Aerosol - 340 g / 12 oz (sold individually or Box of 12)
Corrosion Shield
S2S Corrosion Shield works by polar bonding to metal, like a magnet to steel, and displacing water and oxygen. It creates an even, lubricating film that creeps into hard to reach areas, providing long lasting protection and excellent anti-seize capabilities.
For heavy duty protection, try S2S HD Corrosion Shield.
Recommended Uses
• Wellheads
• Pipelines & Piping
• Electrical & Electronics
• Fittings & Flanges
• Offshore rigs
• Machined surfaces
• Batteries
• Sculptures
• Cranes
• Motors
Advantages
• 500+ hours without corrosion in ASTM B117-18 Salt Spray Chamber Test
• Prevents rust and corrosion for up to 3 years
• Rubber compatible to ASTM D471 standards
• Wide range of operating temperatures
• Dielectric strength 36,000 volts
• Can be applied over existing rust and paint
• Can be applied to damp surfaces
• Removes easily with high pH detergent
• Self-healing; stops rust on contact
• Non-hazardous and easy to use
• Ultra low VOCs; Zinc-Free
• Water discharge meets the requirements of the California Environmental Protection Agency
It can be applied to rusted, painted, damp, and bare metal. No sandblasting required. Remove all debris, soap, and degreaser from the metal surface. To ensure long-lasting protection of corroded or previously coated surfaces, a wire brush may be used to remove all or most loose corrosion. We do not recommend topcoats of paint over the top of Corrosion Shield.
For best results, apply when surface temperatures are between 41F and 99F (5°C – 37°C). Apply a thicker coat over known problem areas, edges, cracks, and welds. Extremely old, porous metal may require a thicker-than-normal layer due to the product's tendency to penetrate deep.
Application
Tech Stuff
