Bridge & Steel
Corrosion Control
S2S Bridge & Steel Corrosion Control is the ultimate rust inhibitor for bridges and steel structures. It requires no sandblasting and works just as well at preventing rust and corrosion when applied over existing paint as when applied to bare metal.
Product Variations
Drum - 205 L / 55 gal
Pail - 20 L / 5 gal
Can - 3.78 L / 1 gal
Recommended Uses
-
Cable-Stayed and Suspension Bridges
-
Truss Bridges
-
Beam Bridges
-
Arch Bridges (wrought iron)
-
Cantilever Bridges
Advantages
-
No sandblasting required
-
Polar bonds to all metals, even over existing rust and paint
-
Can be applied to damp surfaces
-
Stops rust on contact
-
Creates an even, thin film
-
Creeps into pitting corrosion, cracks and crevices
-
Prevents corrosion on bolts
-
Dielectric properties; stops electrolysis
It can be applied to rusted, painted, damp, and bare metal. No sandblasting required. Remove all debris, soap, and degreaser from the metal surface. To ensure long-lasting protection of corroded or previously coated surfaces, a wire brush may be used to remove all or most loose corrosion.
For best results, apply when surface temperatures are between 41F and 99F (5°C – 37°C). Apply a thicker coat over known problem areas, edges, cracks, and welds. Apply by using a brush, putty knife, or gloved hand. Feather a light coating of the paste over the rusted area until fully covered.
Application
Download
Tech Data Sheet
Tech Stuff
